When HN users recommended it
1 HN user recommended this in 2021, in one comment.
20072026
Each tall tick is one HN user's first recommendation. A short tick is the same user again. Click a tick to jump to the comment.
1 HN user recommended this in 2021, in one comment.
Each tall tick is one HN user's first recommendation. A short tick is the same user again. Click a tick to jump to the comment.
Where are you finding these $30 drill presses?
$21: https://www.amazon.com/Irwin-Tools-Drill-Press-226340/dp/B00...
$25: https://www.harborfreight.com/4-inch-jaw-capacity-drill-pres...
You don't need a high-dollar Kurt milling vise for a drill press, and you only need to constrain the part in one degree of freedom (rotation about Z axis). Just put a single fastener in your table and drop the slots in that vise over it. Gravity and quill pressure hold it in Z, the table holds it flat against rotation about X and Y, and you want it to have the ability to slide a bit in X and Y to let the drill find the center of your punch/pilot hole. If the drill catches, the torque will push against the stud and it can't move.