When HN users recommended it
1 HN user recommended this in 2023, in one comment.
20072026
Each tall tick is one HN user's first recommendation. A short tick is the same user again. Click a tick to jump to the comment.
1 HN user recommended this in 2023, in one comment.
Each tall tick is one HN user's first recommendation. A short tick is the same user again. Click a tick to jump to the comment.
I only want to add that you need resistors with slightly ticker leads. Most of the cheap resistors have either too soft leads or too thin and they do not provide a good contact with the breadboard.
I use quite expensive (comparing to noname resistors) Velleman Sets similar to: https://www.amazon.com/Velleman-RES-E12-Pack-E12-Resistors/d...
The same applies to wires that you use for the connections. Do not buy the very thin ones. An example of what I use: https://www.adafruit.com/product/3175
Jumpers are good but if you have to do a lot of wiring (e.g. 8 address lines + 8 data lines) then using custom cut wires is the best.