When HN users recommended it
1 HN user recommended this in 2023, in one comment.
20072026
Each tall tick is one HN user's first recommendation. A short tick is the same user again. Click a tick to jump to the comment.
1 HN user recommended this in 2023, in one comment.
Each tall tick is one HN user's first recommendation. A short tick is the same user again. Click a tick to jump to the comment.
Those little "benchtop extractors" with a fan and a carbon filter are absolutely useless.
If I soldered a lot more often, I might feel differently, but as it is I sorta disagree with this sentiment. All I use for soldering is a combination of one of these[1] "fume extractor" devices and a cheapo $10 desk fan I bought at Walmart.
Now maybe I'm just not inclined to be particularly sensitive to flux fumes, but with the bench fan blowing towards my soldering area, and the "fume extractor" sucking away from it on the other end, I don't notice soldering fumes at all. If I don't turn the fans on though, the difference is acute. I never solder more than a few seconds without realizing I've made that mistake on the occasions when it happens as I notice the fumes immediately otherwise.
Now I'm not saying that this combo is the be-all, end-all, or that it's compliant with any particular regulatory regime, nor am I even saying that it's sufficient for anybody in particular. I'm just saying that to say that a setup like this is "absolutely useless" is not correct, in my experience.
[1]: https://www.amazon.com/gp/product/B07VWDN29F/ref=ppx_yo_dt_b...