When HN users recommended it
1 HN user recommended this in 2023, in one comment.
20072026
Each tall tick is one HN user's first recommendation. A short tick is the same user again. Click a tick to jump to the comment.
1 HN user recommended this in 2023, in one comment.
Each tall tick is one HN user's first recommendation. A short tick is the same user again. Click a tick to jump to the comment.
I did spend the time to find 3d models on the web to plug into my 3d views and it was definitely helpful.
Rather than paper, I think you could Kicad-design a 2D grid of holes matching an existing proto board (https://www.amazon.com/ElectroCookie-Solderable-Breadboard-E...) and then do the placement and routing in Kicad, and then finally assemble the board in place. To avoid fritzing.